The final stage of the interior of the room is the installation of interior doors. You should not do this before, since the doors can be damaged in the doors repair.
When choosing and buying a door, do not forget to pay attention to the size: it should be a few centimeters less than the doorway. After that, you need to carefully inspect the door. If there are no disadvantages, you can proceed to the installation.
The first thing to do is the excavations for the loops. It is recommended to place them at a distance of 20 centimeters from the upper and lower edges. You will need a hammer and a chisel for the manufacture of recesses. An open surface in order to avoid moisture penetration is recommended to be covered with varnish, but there is no need to fix the loops yet.
The next important stage is the castle installation. Mark its location in the first place. Traditionally, locks are located at a distance of 90 centimeters from the lower edge of the door leaf. After the removal of the recess, the open space also needs to be treated. Then, using the castle itself as a stencil, you need to make holes under the handle and shut -off valves. After that, the lock can be fixed.
The next step during installation is the manufacture of recesses for the loops on the door frame. They must be made identical in that there are already on the doorbell of the door. When drilling holes for screws, observe accuracy and accuracy.
The door box also needs to be assembled. Vertical racks must be sawn down in accordance with the size of the canvas. In the corner connection of the box it is better to use screws. Such fixation will be more reliable and stronger. After you inserted the box into the opening, you need to put the spacers. At this stage, the use of the level is required. If everything is done correctly, with the help of screws you can fix the loops.
Submission of the installation of the door itself, make sure that in the open state it does not seek to close or open. If all the rules are observed and the door is set correctly, then it will remain in a stationary state.
The final stage – installation of platbands. They need to be drunk at an angle of 45 degrees. For pinching, you can use finish cloves.
