Garage automatic gates require, like any automatic mechanism, timely repair and prevention. If you have a need for a preventive inspection or repair of your automatic work, you can contact a professional service. As a rule, experts go home to customers to conduct inspections and repair of a gates of any type, so you will not need to take off the gate to be examined or repaired. The repair of a gate with an automatic mechanism can be carried out in two areas – this is automation and mechanics. Mechanical work, as a rule, includes the repair of load -bearing elements, cash, mechanisms, canvases, coils, etc. D. In addition, the garage gates are inspected by specialists for distortion of the canvas, stuck the garage canvas, distort or jamming rollers in roller holders. It should be noted that the repair of the garage gap is carried out without prior lubrication of all elements and checking roller compounds. The state of friction, alignment, etc. is also checked. In the garage gates, it may be necessary to replace the torsion mechanism, any of the spare parts, canvases, rollers, etc. Repair in some cases can be carried out by one employee. If you require a complete replacement of a torsion mechanism, a cable or track system, then you can no longer do without a team of professionals, at least 2 people will be required.
If you have a sliding gate that are considered the most difficult to repair, then remember that the main causes of the malfunction, as a rule, have two – this is the location of rollers at different levels and curvature of the bearing beam. If the divergence of alignment can be detected immediately, then the breakdown of the gate can be avoided by adjusting the axis of the support rollers. Pay attention to the work of your gate every day – no, even small difficulties in closing the gate should not be. The beam curvature is repaired exclusively by replacing the beam. The sliding gates, as a rule, are repaired by a whole team of installers, consisting of two or three people.
Repair of automation is required in cases where the gates are easily folded manually, but the electronics signal do not respond. In this case, experts check electronic circuits, control units. Repair of automation may also include checking the docking of the final positions of the gate, the correct operation of the switches, checking access and control systems. Drives are also repaired, batteries change, spare parts are replaced, if necessary.